---

Note This Is For The Belkin Routers I Am Not Sure If Its The Same For Other Router Types

---

Step 1. Go To Start

Step 2. Click Run

Step 3. Type "cmd"

Step 4. When The Command Screen Comes Up Type "ipconfig"

Step 5. Scroll Up To Ip Address And Write It Down Next To It There Should Be Numbers Like
192.168. And Then Two More Numbers

Step 6. Below It Should Be Default Gateway Next To It There Should Be Numbers Like
192.168. And Then Two More Numbers

Step 7. Type Those Numbers In The Address Bar Like This Http://192.168.2.1/ ( Just An Example)

Step 8. When You Get To A Screen Click Login Near The Top.

Step 9. Just Leave It Blank And Click Submit.

Step 10. Now On The Left Hand Side Under The FireWall Tab Click Virtual Servers

Step 11. Choose The Game Starcraft.

Step 12. In The Inbound Port Boxes Put 6112 - 6119

Step 13. Choose Type TCP

Step 14. In The Private Ip Address Box Put Your Ip Address That You Wrote Before

Step 15. In The Private Port Boxes Put 6112 - 6119

Step 16. Click The Enable Box

Step 17.Repeat Steps 11 Through 16 Again But For Step 13 Change TCP To UDP

Step 18. Click Apply Changes

Step 19. Host Starcraft Games

Ps - Sorry I Don't Have Pictures I Don't Know How To Get Them

I think www.portforward.com is a much more practical solution for finding out how to forward your ports rather than devoting a whole thread to it.

Ya But My Way Takes Less Than 5 Minutes To Do.

The methods on portforward.com take just as much time and lower, also the site covers a huge array of routers. All you need to do is just take the time to place a few clicks and follow the directions.

I know how to port forward. I recently tried to host a game on SC and forgot that I had reset my router a while ago. So when I couldn't host I eventually realized I forgot to forward my ports. It only took me a min or two to forward the ports on my router and then I was hosting a game

I still have lat despite my ports being forwarded. Any help with that?

Umm.... I Don't Know It Worked For Me So... Suck To Be You

"cmd" can't be found?
I have Win ME

Use "command" instead then.

thoghut i already tried that. ty
Ooh! its all DOSsy

Alrighty, problem number two. I put all those good numbers in and got this.
http://img507.imageshack.us/img507/872/portforwardingfs7.png
Now, if i click on any other tab, it gives me a log-in. if i leave it blank, then it pop-ups again. if i cancel, then it says "Permission is denied"
Halp?

Post has been edited 1 time(s), last time on Jul 26 2008, 3:17 pm by Hug A Zergling.

...which I don't know

This guide sucks, the author needs to learn how to capitalize.